Rinnai Tankless Water Heater · SENSEI series · SENSEI RX/CX series · Non-SENSEI series

14Thermal Fuse or Overheat Sensor

A safety device that protects against overheating has tripped or its circuit is open.

Difficulty
Technician
Safety
Call a pro
Source
Confirmed by manufacturer
Last checked
2026-11-21
Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

How to fix Rinnai code 14

  1. Check the outside vent terminal for snow, leaves, nests or anything blocking it
  2. Reset: turn off hot water taps and press ON/OFF on the controller twice
  3. If the code comes back, call a licensed Rinnai service provider

What 14 means on your Rinnai

Code 14 is a safety lockout. Rinnai's checks include the overheat sensor wiring harness, the gas type the heater is connected to, clearances around the heater and vent terminals, and a single DIP switch on the control board that must be OFF.

What a technician will check: the overheat sensor and thermal fuse circuit, gas type and pressures, and the DIP switch. Rinnai notes that if that DIP switch is ON, the heater shows code 71 because it blocks the gas valve.

Because it's an overheat safety, don't keep resetting it. Have it inspected.

Likely causes

  • Overheat sensor wiring loose or damaged
  • Wrong gas type connected
  • Poor clearances around the heater or vent
  • Control-board DIP switch set to ON

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.