32Outgoing Water Temperature Thermistor
The sensor that measures water leaving the heater is reading out of range.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 032 · Confirmed by manufacturer · checked 2026-11-21
33Heat Exchanger Thermistor
The heat exchanger temperature sensor is reading out of range.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 033 · Confirmed by manufacturer · checked 2026-11-21
34Combustion Air (Non-SENSEI) / Lime Detecting (SENSEI RX/CX) Thermistor
The combustion air temperature sensor, or on SENSEI RX/CX the lime (scale) detecting sensor, is reading out of range.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 034 · Confirmed by manufacturer · checked 2026-11-21
35Tank Temperature Sensor
On the RH180 hybrid, the tank temperature sensor is reading out of range.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 035 · Confirmed by manufacturer · checked 2026-11-21
38Exhaust Gas Temperature Sensor
The exhaust temperature sensor is reading out of range.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 038 · Confirmed by manufacturer · checked 2026-11-21
41Freeze Protection Sensor (Outdoor Models)
On outdoor models, the freeze protection sensor is disconnected, shorted or reading out of range. Make sure it isn't covered by insulation.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 041 · Confirmed by manufacturer · checked 2026-11-21
51Inlet Water Temperature Thermistor
The incoming water temperature sensor is reading out of range. The heater may keep running while it flashes 51.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 051 · Confirmed by manufacturer · checked 2026-11-21
58Secondary Heat Exchanger Sensor
Rinnai says this code indicates scale build-up inside the secondary heat exchanger, which needs flushing per the owner's manual.
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
Also shown as: 058 · Confirmed by manufacturer · checked 2026-11-21
Parts and supplies for this fix
- Tankless water heater flushing kit (pump + hoses)Check price
We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.
Sources
- Rinnai: Troubleshooting Tankless Water Heater Diagnostic Codes (doc. 100000652) manufacturer checked 2026-11-21
Spotted an error on this page? Report it and we'll re-check it against the manual.