Rinnai Tankless Water Heater · Non-SENSEI series

Rinnai RH180 Hybrid Tank-Tankless Codes (07, 13, 30, FE)

These codes apply only to the RH180 hybrid tank-tankless water heater: circulation flow, combustion, and the flammable vapor sensor. FE means flammable vapors were detected: make sure none are present before anyone restores power or gas.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

07Circulation Flow Rate Below 2.1 GPM (RH180)

On the RH180 hybrid, circulation flow dropped below 2.1 GPM. Check power, that the water supply is on at 30 PSI or more, and that the pump runs.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 007, 7 · Confirmed by manufacturer · checked 2026-11-21

13Combustion (RH180)

On the RH180 hybrid, a combustion problem: venting, combustion air, altitude settings or gas pressure.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 013 · Confirmed by manufacturer · checked 2026-11-21

30Flammable Vapor Sensor (RH180)

On the RH180 hybrid, the flammable vapor sensor or its wiring has a fault.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 030 · Confirmed by manufacturer · checked 2026-11-21

FEFlammable Vapors Detected (RH180)

The RH180 detected flammable vapors. Make sure no flammable vapors are present before power and gas are restored.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.