Rinnai Tankless Water Heater · SENSEI series · SENSEI RX/CX series · Non-SENSEI series

Rinnai Control & Flow Codes (03, 05, 21, 65, 66, 70, FF, SE)

These codes cover the control board, water and bypass flow control devices, data transfer after a board replacement, and service or cascade indicators. Most need a technician; FF and SE are informational.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

03Power Interruption During Bath Fill

Power was interrupted while a bath fill was running. Turn off hot water, then press ON/OFF on the controller twice to reset.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice

Also shown as: 003, 3 · Confirmed by manufacturer · checked 2026-11-21

05Bypass Flow Control Device

The bypass flow control device isn't working correctly.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 005, 5 · Confirmed by manufacturer · checked 2026-11-21

21Data Transfer Error

After a control board replacement, the settings weren't transferred or programmed correctly.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 021 · Confirmed by manufacturer · checked 2026-11-21

65Water Flow Control Device

The water flow control (servo) valve failed, for example it didn't close during a bath fill. Turn off the water flow.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 065 · Confirmed by manufacturer · checked 2026-11-21

66Bypass Flow Servo

The bypass flow servo isn't working correctly.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 066 · Confirmed by manufacturer · checked 2026-11-21

70PC Board Fault

The control board has a fault. Settings and wiring are checked before the board is replaced.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: 070 · Confirmed by manufacturer · checked 2026-11-21

FFMaintenance Has Been Performed

Not a fault: a marker a service provider adds to the code history after servicing the heater.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

SECascade Diagnostic Display

Shown on multi-unit (cascade) systems to indicate a diagnostic code on one of the linked heaters.

  1. Reset: turn off hot water taps and press ON/OFF on the controller twice
  2. If the code comes back, call a licensed Rinnai service provider

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.