How to fix Rinnai code 10
- Make sure the condensate drain line isn't clogged, kinked or frozen
- Clean the air intake filter under the front cover (power off first)
- Check the outside vent terminal for snow, leaves, nests or anything blocking it
- Reset: turn off hot water taps and press ON/OFF on the controller twice
- If the code comes back, call a licensed Rinnai service provider
What 10 means on your Rinnai
On SENSEI and SENSEI RX/CX heaters, the first thing Rinnai checks for code 10 is the condensate drain: if it clogs or freezes, condensate backs up into the trap and the heater shuts off to prevent spillage.
Next is the air intake filter, under the front cover at the top right of the cabinet, then the whole intake and exhaust vent run inside and outside the building.
What a technician will check: that the venting materials are approved for your model, joints are fully seated, the equivalent vent length is within limits (Rinnai counts each 90° elbow of its concentric vent as 6 ft and each 45° as 3 ft), and that foam sealant hasn't collapsed the pipe where it passes through the wall.
Never run the heater with the vent disconnected; exhaust gases must be vented outdoors.
Likely causes
- Clogged or frozen condensate drain line (SENSEI models)
- Dirty air intake filter
- Blocked or improperly installed vent pipe
- Vent too long or collapsed where it passes through the wall
Parts and supplies for this fix
- Condensate neutralizer / drain line suppliesCheck price
We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.
Sources
- Rinnai: Troubleshooting Tankless Water Heater Diagnostic Codes (doc. 100000652) manufacturer checked 2026-11-21
Spotted an error on this page? Report it and we'll re-check it against the manual.