Rheem Tankless Water Heater · RTG non-condensing tankless

14Water Heater Overheating

The heater detected overheating and shut down.

Difficulty
Technician
Safety
Call a pro
Source
Confirmed by manufacturer
Last checked
2026-11-21
Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

How to fix Rheem code 14

  1. Reset: turn off hot faucets, power the heater off at the remote, wait about 5 minutes and turn it back on
  2. If the code is still shown, note it and call a qualified service technician

What 14 means on your Rheem

Rheem's owner chart lists code 14 as the water heater overheating, with the instruction to contact a dealer or qualified technician. Rheem's service manual for its condensing models notes that overheat-limit trips are normally caused by inadequate or wrong gas supply and/or venting.

Likely causes

  • Overheating detected by the safety limit

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.