Rheem Tankless Water Heater · RTGH-S condensing tankless (IKONIC)

Rheem IKONIC Motor, Valve & Flame Codes (A055, A061, A063, A065, A066, A071, A072)

These RTGH-S codes involve the venturi gas control motor, blower, recirculation pump, water volume and bypass valves, the gas-air ratio valve and flame rod. All are technician repairs.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

A055Gas Motor Failed

The motor that positions the venturi's air-volume butterfly valve isn't working properly.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 055 · From a service manual · checked 2026-11-21

A061Blower RPM Signal Incorrect

After the fan starts, its RPM signal isn't correct.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 061 · From a service manual · checked 2026-11-21

A063Pump Abnormality

The water flow sensor doesn't detect flow while the recirculation pump is running.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 063 · From a service manual · checked 2026-11-21

A065Water Volume Control Valve Malfunction

The water volume control valve, which limits flow when demand exceeds capacity, isn't working.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 065 · From a service manual · checked 2026-11-21

A066Water Bypass Control Valve Malfunction

The bypass valve motor isn't working properly.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 066 · From a service manual · checked 2026-11-21

A071Gas-Air Ratio Valve Malfunction

The flame rod detected a flame for 8 seconds after the heater was turned off. Turn off the gas and call a technician.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 071 · From a service manual · checked 2026-11-21

A072Flame Rod Malfunction

The flame rod detected a flame before the igniter was activated.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 072 · From a service manual · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.