Rheem Tankless Water Heater · RTG non-condensing tankless

Rheem RTG Tankless Component Codes (31, 33, 61, 66)

On Rheem RTG non-condensing tankless heaters, these codes point to a failed component: the inlet or outlet thermistor, the blower motor, or the bypass motor. Rheem's owner chart says to contact a dealer or qualified service technician for each.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

31Faulty Inlet Thermistor

The inlet water temperature sensor has failed.

  1. Reset: turn off hot faucets, power the heater off at the remote, wait about 5 minutes and turn it back on
  2. If the code is still shown, note it and call a qualified service technician

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

33Faulty Outlet Thermistor

The outlet water temperature sensor has failed.

  1. Reset: turn off hot faucets, power the heater off at the remote, wait about 5 minutes and turn it back on
  2. If the code is still shown, note it and call a qualified service technician

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

61Faulty Blower Motor

The combustion blower motor has failed.

  1. Reset: turn off hot faucets, power the heater off at the remote, wait about 5 minutes and turn it back on
  2. If the code is still shown, note it and call a qualified service technician

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

66Faulty Bypass Motor

The bypass valve motor has failed.

  1. Reset: turn off hot faucets, power the heater off at the remote, wait about 5 minutes and turn it back on
  2. If the code is still shown, note it and call a qualified service technician

Also shown as: — · Confirmed by manufacturer · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.