Rheem Tankless Water Heater · RTGH-S condensing tankless (IKONIC)

Rheem IKONIC Thermistor Codes (A031, A032, A033, A035, A036)

On Rheem's condensing RTGH-S (IKONIC) heaters, these codes mean one of the temperature sensors (inlet, heat exchanger, outlet, exhaust) is out of range or not connected properly. A technician checks the connectors and resistance (Rheem specifies 7–23 kΩ) and cleans scale off the sensor before replacing it.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

A031Inlet Thermistor Malfunction

The inlet water temperature sensor is out of range.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 031 · From a service manual · checked 2026-11-21

A032Heat Exchanger Thermistor Malfunction

The heat exchanger temperature sensor is out of range.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 032 · From a service manual · checked 2026-11-21

A033Outlet Thermistor Malfunction

The outlet water temperature sensor is out of range.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 033 · From a service manual · checked 2026-11-21

A035Improper Thermistor Connection

One or more thermistors has a poor connection or is plugged into the wrong place.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 035 · From a service manual · checked 2026-11-21

A036Exhaust Thermistor Malfunction

The exhaust temperature sensor is out of range.

  1. If the code is still shown, note it and call a qualified service technician

Also shown as: 036 · From a service manual · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.