Goodman Furnace · GMVC96 two-stage variable-speed furnaces

Goodman Two-Stage Furnace Pressure Switch & Memory Codes (E1, E8, d0, d4)

These GMVC96 codes cover pressure switches stuck closed and missing or invalid shared data on the control. They need a technician; the data codes are fixed with a model-specific memory card from a Goodman distributor.

Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

d0No Shared Data

The control has no shared data set and can't run; a model-specific memory card is needed.

  1. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  2. If the code returns, call a licensed HVAC technician

Also shown as: D0 · From a service manual · checked 2026-11-21

d4Invalid Memory Card Data

The control rejected the memory card data, usually a card for a different model.

  1. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  2. If the code returns, call a licensed HVAC technician

Also shown as: D4 · From a service manual · checked 2026-11-21

E1Low Stage Pressure Switch Stuck Closed

The low-stage pressure switch is closed with the inducer off: faulty switch or wiring.

  1. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  2. If the code returns, call a licensed HVAC technician

Also shown as: e1 · From a service manual · checked 2026-11-21

E8High Stage Pressure Switch Stuck Closed

The high-stage pressure switch is stuck closed, so the furnace runs on low stage only.

  1. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  2. If the code returns, call a licensed HVAC technician

Also shown as: e8 · From a service manual · checked 2026-11-21

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.