Goodman Furnace · GM9S single-stage 92%/96% furnaces

EE2Pressure Switch Open

The pressure switch didn't close after the inducer fan started, which usually means a venting or drain restriction.

Difficulty
Moderate
Safety
Use caution
Source
From a service manual
Last checked
2026-11-21
Safety: Turn the power off before any checks inside the unit.

How to fix Goodman code EE2

  1. Check the PVC intake and exhaust pipes outside for snow, ice, nests or debris
  2. Make sure the condensate drain line and trap aren't clogged
  3. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  4. If the code returns, call a licensed HVAC technician

What EE2 means on your Goodman

EE2 is one of the most common winter codes on high-efficiency furnaces. The pressure switch proves the inducer is moving combustion air; if the intake or exhaust is blocked, or condensate backs up, it won't close.

Goodman lists disconnected pressure switch hose, a faulty switch or wiring, and restricted air intake or flue piping as probable causes. Snow drifts over the outdoor pipes are a frequent culprit.

Likely causes

  • Blocked intake or exhaust pipe
  • Clogged condensate drain
  • Disconnected or kinked pressure switch hose
  • Faulty pressure switch or inducer

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.