Goodman Furnace · GM9S single-stage 92%/96% furnaces

EE6Low Flame Signal

The furnace runs, but the flame sensor's signal is weak. It often leads to short cycling and lockouts.

Difficulty
Moderate
Safety
Use caution
Source
From a service manual
Last checked
2026-11-21
Safety: Turn the power off before any checks inside the unit.

How to fix Goodman code EE6

  1. Reset: turn the thermostat off for 5–20 seconds and back on, or switch off power to the furnace for at least 5 seconds
  2. Have a technician clean or reposition the flame sensor and check gas pressure

What EE6 means on your Goodman

Goodman's chart says the flame-sense micro-amp signal is minimal and lists a coated or oxidized flame sensor first. Cleaning the flame sensor is routine maintenance during a furnace tune-up.

If cleaning doesn't fix it, a technician checks the sensor's position in the flame and the burner's gas pressure and combustion air.

Likely causes

  • Coated or oxidized flame sensor
  • Sensor not positioned in the flame
  • Lazy flame from incorrect gas pressure or combustion air

Parts and supplies for this fix

We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.