Navien Tankless Water Heater · NPE-A2 series · NPE-S2 series

E110Abnormal Air Pressure

The heater detected abnormal air pressure in its venting, usually from a blocked exhaust or a dirty intake filter.

Difficulty
Moderate
Safety
Use caution
Source
Confirmed by manufacturer
Last checked
2026-11-20
Safety: Turn the power off before any checks inside the unit.

How to fix Navien code E110

  1. Check that the exhaust pipe is free of obstructions (snow, leaves, nests)
  2. Clean the intake air filter (manual page 14)
  3. Press the Back button on the front panel to reset the water heater
  4. If the code comes back: contact Navien Technical Support (1-800-519-8794) or a licensed technician

What E110 means on your Navien

E110 is the code Navien says you'll see when the air intake filter is clogged by dust or lint: "the water heater will cease to operate and 'Error Code 110' will appear" (section 4.5).

Check the outside vent terminations for snow, leaves or nests, then clean the intake air filter: power off, disconnect power, remove the front cover, remove the screw at the top-left filter, clean it with a toothbrush under running water, let it dry fully, refit, and restore power.

Navien recommends cleaning this filter every 3–4 months to prevent E110 from coming back.

Likely causes

  • Obstructed exhaust pipe
  • Dirty intake air filter

Parts and supplies for this fix

We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.

Common questions

How often should I clean the Navien air filter?

Every 3–4 months, according to Navien's manual.

Will E110 clear by itself?

No. Once the cause is fixed, press the Back button to reset the heater.

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.