Navien Tankless Water Heater · NPE-A2 series · NPE-S2 series

E016Overheating of Heat Exchanger

The heat exchanger got too hot and the heater shut down to protect itself. Scale build-up and restricted water flow are typical reasons.

Difficulty
Moderate
Safety
Use caution
Source
Confirmed by manufacturer
Last checked
2026-11-20
Safety: Turn the power off before any checks inside the unit.

How to fix Navien code E016

  1. Clean the cold water inlet filter (manual section 4.4)
  2. Flush the heat exchanger (manual section 4.3; needs a flushing kit and circulation pump)
  3. Press the Back button on the front panel to reset the water heater
  4. If the code comes back: contact Navien Technical Support (1-800-519-8794) or a licensed technician

What E016 means on your Navien

E016 means the heat exchanger overheated. Navien's remedies are to clean the cold water inlet filter and flush the heat exchanger, the two maintenance tasks that restore water flow and remove scale.

Cleaning the inlet filter (section 4.4): drain the heater, remove the cold water inlet filter (and the recirculation inlet filter on A2 models), rinse under cold running water, scrub if needed, refit and refill.

Flushing (section 4.3): with the power off and the hot/cold isolation valves closed, a circulation pump pushes a diluted cleaning solution from a 5-gallon bucket through the heater for at least 45 minutes, then the heater is rinsed with fresh water for 5 minutes. It needs isolation valves (such as Navien's valve kit), three hoses and a pump.

Navien calls flushing "a somewhat complicated procedure" and warns that improper maintenance can void the warranty. If you're unsure, have a technician do it.

Likely causes

  • Clogged cold water inlet filter
  • Scale build-up in the heat exchanger

Parts and supplies for this fix

We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.

Common questions

What causes Navien E016?

Usually scale build-up or a clogged cold water inlet filter, which reduce water flow and let the heat exchanger overheat.

Does flushing void the Navien warranty?

No, flushing is recommended maintenance, but Navien warns that improper maintenance can void the warranty, so follow the manual or use a technician.

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.