Navien Tankless Water Heater · NPE-A2 series · NPE-S2 series

E030Exhaust Overheating

The flue (exhaust) got hotter than 149 °F (65 °C), so the heater shut down.

Difficulty
Moderate
Safety
Use caution
Source
Confirmed by manufacturer
Last checked
2026-11-20
Safety: Turn the power off before any checks inside the unit.

How to fix Navien code E030

  1. Clean the cold water inlet filter (manual section 4.4)
  2. Flush the heat exchanger (manual section 4.3; needs a flushing kit and circulation pump)
  3. Press the Back button on the front panel to reset the water heater
  4. If the code comes back: contact Navien Technical Support (1-800-519-8794) or a licensed technician

What E030 means on your Navien

E030 means the exhaust got hotter than 149 °F (65 °C), so the heater shut itself down. Navien gives the same remedies as for E016: clean the cold water inlet filter and flush the heat exchanger.

If E030 and E016 keep returning, scale build-up is the usual suspect. See the E016 page for the filter-cleaning and flushing steps from the manual.

Likely causes

  • Clogged cold water inlet filter
  • Scale build-up in the heat exchanger

Parts and supplies for this fix

We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.