Navien Tankless Water Heater · NPE-A2 series · NPE-S2 series

E012Flame Loss

The burner lit but the flame went out while the heater was running.

Difficulty
Moderate
Safety
Use caution
Source
Confirmed by manufacturer
Last checked
2026-11-20
Safety: Turn the power off before any checks inside the unit.

How to fix Navien code E012

  1. Clean the intake air filter (manual page 14)
  2. Make sure the power cord is plugged into a properly grounded outlet
  3. Press the Back button on the front panel to reset the water heater
  4. If the code comes back: contact Navien Technical Support (1-800-519-8794) or a licensed technician

What E012 means on your Navien

E012 means the flame was established and then lost while the heater was running. Navien's remedies are to clean the intake air filter and to confirm the power cord is properly grounded.

The manual recommends cleaning the air intake filter every 3–4 months. It sits at the top left inside the front cover, held by one screw; clean it with a toothbrush under running water and let it dry completely before refitting (manual section 4.5).

Likely causes

  • Dirty intake air filter
  • Improper electrical grounding

Parts and supplies for this fix

We may earn a commission from purchases made through these links. Confirm the part matches your exact model number before buying.

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.