Navien Tankless Water Heater · NPE-A2 series · NPE-S2 series

E004False Flame Detection

The heater sensed a flame when there shouldn't be one and shut down as a safety precaution.

Difficulty
Technician
Safety
Call a pro
Source
Confirmed by manufacturer
Last checked
2026-11-20
Safety: Involves gas, venting, refrigerant or electrical parts. Do the basic checks only, then call a licensed technician.

How to fix Navien code E004

  1. Make sure the power cord is plugged into a properly grounded outlet
  2. Press the Back button on the front panel to reset the water heater
  3. If the code comes back: contact Navien Technical Support (1-800-519-8794) or a licensed technician

What E004 means on your Navien

E004 means the heater detected a flame signal when no flame should be present, so it shut down for safety. The manual's remedy is to make sure the power cord is properly grounded.

If it persists after checking grounding and resetting, a technician should inspect the flame-sensing circuit.

Likely causes

  • Improper electrical grounding
  • Flame-sensing fault (technician diagnosis)

Sources

Spotted an error on this page? Report it and we'll re-check it against the manual.